A concrete slab is a rectangular, flat and sturdy structure made of concrete. Concrete slabs are 10-50 cm thick. They are mainly used in the manufacturing process. They are used for reinforcing floors, roofs, bridge decks, homes and in various buildings. If you are planning to build a new home in Brisbane. So you may be wondering about the relative benefits of a raised pier and beam floor compared to a floor of concrete slab Brisbane. Most potential homeowners and builders also tend to be concerned with the relative cost of these two types of building systems.

Cost Considerations

The cost difference between these floors is minimal, assuming that industry design standards and local building codes are met. The location of the home site is usually the determining factor in the selection of the system along with the final cost. Climatic conditions, the slope of the property, base flood height and soil type are all factors that determine the costs and benefits of each type of flooring.

Climate Makes a Difference

The footings for the floor foundation should be made below the frost line. It is so deep in the soil that groundwater will freeze. Foundations above the frost line will feel warm. And thus the foundation will suffer. Raised floor construction can use economical piers in cold northern climates. Which are drilled below the frost line. Slabs require deep continuous footings or concrete walls that come at a high cost.

Site Considerations

Sloping lots require a raised slab construction with increased labor and material costs. If your building site is located at a height close to the base of the flood height. So a raised parquet floor may be the logical choice. Base flood elevation (BSE) is the height calculated On which the flood water is estimated to increase during the flood event of 100 years. Base flood elevations are shown on FEMA Flood Insurance Rate Maps (FIRMs) and flood profiles. There is a regulatory requirement for height or flood proofing of BFE structures. Lending institutions and federal agencies use FIRM to locate properties and buildings in relation to mapped flood hazards. And how to determine whether flood insurance is required when granting a loan. You don’t always need to be close to a river, lake, or coastal area to be located in a flood-prone area.

If the soil composition consists of a large percentage of clay or other type of material that easily absorbs water. So the resulting soil movement will not allow you to build a slab floor without the risk of damage caused by movement in the slab. The resulting repairs are difficult and expensive to make.

Pesky Pests

Parts of Australia with hot humid climates, such as the southeast, are at increased risk for termites. The raised floor has been properly supplied with insect shields, which will greatly reduce the potential for termite damage. A crawl space under a raised floor can help with termite inspection as well as provide access to plumbing, HVAC and electrical systems. Concrete slabs have no access to these systems, so repairs can be a real headache. For example plumbing leaks can cause major damage and repair costs.

Curb Appeal

Many people feel that raised floor systems provide more curb appeal and a more architecturally attractive home. This allows for greater design flexibility, porches and decks as well as future additions. This type of floor Some type of architectural style relies on a raised floor system to provide the required overall appearance of the desired design. There are a lot of preconceived notions about the cost and merits of the two types of flooring systems. The future homeowner and builder should carefully consider the special circumstances involved in their individual project before deciding which route to go.

Designs and Shapes

These are available in different shapes and designs. Suspended slabs are made to produce and maintain strength and weight. If a change in the design is necessary, it is brought to the bottom of the concrete slab; Whereas the upper or upper part is left unchanged. Some types are written below:

Corrugated concrete slabs: These slabs are made of a combination of steel and concrete. Typically, concrete is released into a reinforcing steel tray to make it stronger for buildings and construction purposes. It also increases the length of the slab and makes it very hard. It is very difficult to bend such a concrete slab Hence, concrete slab Brisbane. provide more strength to the buildings and enhance their ability to withstand the variations of climate and environment. These slabs can also be very heavy.

Ribbed concrete slabs: Special concrete slabs, which are made to increase the strength of buildings. These slabs have special added strength and power in one direction. So, such strong side is used to prevent damaging shaking to buildings.

Waffle concrete slab: Like ribbed concrete slabs, these slabs are designed to increase the strength of buildings. These concrete slabs have extra strength in both directions.

One-way slab: These are powerful and strong concrete slab Brisbane. Structural strength is provided in these slabs in least direction. Such slabs are widely used in buildings.

Two-way slab: Structural strength is given in two directions to increase the slab’s ability to make it suitable for buildings.

Concrete Slab and Constructions

Concrete is available as prefabricated slabs or in situ slabs. Prefabricated slabs are really important and important.  Because they have been widely used in industry. These slabs are manufactured in the factory. And then these are brought to the work site or buildings. It is rigged between steel walls or layers and concrete beams. This act helps buildings and houses to get more strength from these slabs. It depends on the conditions whether the slab will be pre-stressed or post-stressed. Both versions have different features.

These slabs can be unstable according to the situation; It is also used in various buildings. These slabs have advantages as well as many drawbacks. If these slabs are not designed as per the requirement. And if they have flaws like wrong dimensions then these slabs will not fit in the given slot, this situation can be harmful to the buildings. The in situ fabrication mode of slab is very different from that of prefabricated slab. This slab can be used for work and construction purposes. Concrete slab Brisbane has now become the most important part of buildings.

If you are required to drill a hole onto the concrete ground of your commercial or residential property, you will require the assistance of a professional service of Concrete Slab Brisbane.